RUVO 800A Hinge and Strike Jamb Mortising Machine
The RUVO 800a processes both jambs and mullions for exterior doors.
The RUVO 800A Hinge and Strike Jamb Mortising Machine is to be used in conjuction with the machining and preparation for steel door assembly, or whenever a special machine is required for processing jambs only.
The 800A will mortise for two, three, or four hinges and will cut for the strike hole and rectangular faceplate. It will cut the head rabbet as well as the custom sill angle cut.
The operator places the jambs into the machine and pushes down on a foot pedal to clamp. Then the operator will use the router to route out the head rabbet, hinge mortise, sill cut, and strike and dead bolt mortise. A special fixture drill will be used to bore strike and dead bolt.
This machine can be customized to your specifications, for hinge, strike, sill and head cuts. The RUVO 800A is simple to setup and operate as well as affordable.
Hinge and Strike Jamb
Specifications
- Jamb Sizes: 6’6″ to 8’0″ long & 4-9/ 16′ to 10′ wide
- Strike Sizes: 2-1/4″ to 2-3/4″ (1/4″ radius)
- Hinge Sizes: 3″ to 5″ (5/8″ or 1/4″ radius)
*Specifications are subject to change without notice.
Video Demonstration of RUVO 800A
Do You Have any Questions?
Ask it NOW via our Quick Question Form Or, if you prefer, feel free to call the factory.
Machine Questions?
1-800-568-7423 ext. 133
Parts Questions?
1-800-568-7423 ext. 188
Email direct: mmcsales@merrickmachine.com
WORKING TIME
Available to help you from 8am-5pm Central time weekdays.
- Mon–Fri: 08:00–5:00
- Sat: Closed
- Sun: Closed